GB3LE Aerials
GB3LE Hexalators
GB3LE 12v Supply Filters
GB3LE MK 2 Specification
GB3LE MK2 Logic
GB3LE MK 2 TX Layout
 
 
G8MZY logo
 

GB3LE Mark two 70 centimetre repeater

I took over a somewhat sick repeater (29 March 1981, at a Sunday afternoon AGM) The repeater had a transmitter producing a few milliwatts and a receiving system that had been deafened by water in the aerial baluns and water dripping out of the bottom end of the aerial feeder. Some tweaking of the cavities 'by ear' of well meaning, but ill informed 'helpers' also rendered the system somewhat deaf.

I fished the TX out of the hole and was given a quick tutorial by Geoff G3TQF, the original builder of the PA, on what was wrong and how to put it right. When repaired the TX was soaked overnight at 20 watts into a dummy load and as no further problems manifested themselves I took the TX to the GPO 'radio interference' lab (who had better test gear than I did) for a full check on spurious emissions.

Back down the hole with a mountain of test gear and a flask of hot soup, ably assisted by some well equipped out stations that provided calibrated signals and the machine was back on the air. At the time that this work was going on some hash was found on the 12v DC busbars and I resolved to isolate 'LE from the rest of the LV system by means of filters.

The original Hexalator was minus it's case and lying in a dusty heap on the bench. Using an aerosol can of solvent cleaner, the dust was blasted off and when the volatile liquid had evaporated, the unit was encased in the plastic bag that my lunchtime sandwiches had been in. (Not the first time that Leicester's UHF repeater's bits and pieces had been protected in this fashion.)

Originated... May 2001, Revised... 04 December 2001, Revised... 01 May 2002, Upgraded... 09 April 2005,
This page has actually been validated by W3C Javascript Navigational elements removed as per W3C Link Checker version 4.1 (c) 1999-2004 Requirements
Ham Radio favicon